Article Back

SEVERE PLASTIC DEFORMATION STEEL AISI 316

1 GREGER Miroslav
Co-authors:
2 RUSZ Stanislav 2 ŠVEC Jiří 3 KANDER Ladislav 4 KWARTENG Oscar
Institutions:
1 VSB-Technical University of Ostrava, Faculty of Materials Science and Technology, Ostrava, Czech Republic, EU, miroslav.greger@vsb.cz
2 VSB-Technical University of Ostrava, Faculty of Mechanical Engineering, Ostrava, Czech Republic, EU, stanislav.rusz@vsb.cz
3 Material and Metallurgical Research Ltd, Ostrava, Czech Republic, EU, ladislav.kander@mmvyzkum.cz
4 Vítkovice HAMMERING, a.s., Ostrava, Czech Republic, EU, oskar.kwarteng@vitkovice.cz
Conference:
31st International Conference on Metallurgy and Materials, Orea Congress Hotel Brno, Czech Republic, EU, May 18 - 19, 2022
Proceedings:
Proceedings 31st International Conference on Metallurgy and Materials
Pages:
280-285
ISBN:
978-80-88365-06-8
ISSN:
2694-9296
DOI:
https://doi.org/10.37904/metal.2022.4475
Published:
1st November 2022
Proceedings of the conference were published in Web of Science and Scopus.
Metrics:
410 views / 204 downloads
View Full-text Download PDF
Abstract

The technology severe plastic deformation was applied on austenitic steel AISI 316. It was verification of severe plastic deformation application possibility on steel AISI 316 importantly for following applying on similar kinds of steel, because SPD technology influence on fatigue properties was confirmed. It can be predicted on the basis of obtained results that, contrary to low-cycle fatigue the ultra-fine grained material will manifest at fatigue load in the mode of constant amplitude of stress higher fatigue characteristics, particularly fatigue limit.

Keywords: steel AISI 316, severe plastic deformation, mechanical properties, fatigue

© This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Scroll to Top