from the conferences organized by TANGER Ltd.
In the paper the results of investigation of drawing method including simple drawing and shear by computer simulation were presented. The simulation in Deform program was performed. As basic scheme of drawing the industrial variant of LLP “Kaz-Metiz” was chosen. Both two new variants were the schemes of step and alternating drawing proposed in Krakow University of science and technology. The parameters of stress-strain state (strain effective, average hydrostatic pressure) and also drawing load were studied. The comparison of all three models revealed that on the existing drawing equipment in LLP Kaz-Metiz the implementation of any of two offered drawing schemes is possible. The most optimal variant is the scheme of alternating drawing.
Keywords: Drawing, FEM, stress-strain state, load© This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.