Article Back

 INFLUENCE OF THE EDM PROCESS PARAMETERS ON THE SURFACE ROUGHNESS OF ALNICO ALLOYS.

1 DUDEK Dominik
Co-authors:
2 SKOWRON Ewelina 3 JARGIEŁO Adrian
Institutions:
1 Kielce University of Technology, Kielce, Poland, EU, dominik_dudek@op.pl
2 Mesko S.A., Skarżysko-Kamienna, Poland, EU, e.skowron@mesko.com.pl
3 Graduate of Kielce University of Technology, Kielce, Poland, EU, adriajargielo@wp.pl
Conference:
27th International Conference on Metallurgy and Materials, Hotel Voronez I, Brno, Czech Republic, EU, May 23rd - 25th 2018
Proceedings:
Proceedings 27th International Conference on Metallurgy and Materials
Pages:
1079-1084
ISBN:
978-80-87294-84-0
ISSN:
2694-9296
Published:
24th October 2018
Proceedings of the conference were published in Web of Science and Scopus.
Metrics:
510 views / 223 downloads
View Full-text Download PDF
Abstract

This paper deals with the influence of the EDM process parameters on the surface roughness of AlNiCo alloys. A BP 93L machine with an electronic generator was used to perform the machining. The workpiece was made of an AlNiCo alloy. Kerosene was used as a dielectric. During the EDM process, the parameters of current were changed. The impulse time and break time were also changed. The surface roughness and a 3D surface profile were measured. Roughness measurement was carried out using a Talysurf CCI Lite non contact 3D surface profiler. The analysis of the results was carried out with the Statistica 10 program.

Keywords: Electrical discharge machining (EDM), AlNiCo alloys, suface roughness, 3D surface profile

© This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Scroll to Top