Article Back

ANALYSIS OF STRESS AND STRAIN IN ASYMMETRIC ROLL GAP

1 DYJA Henryk
Co-authors:
1 SZYIŃSKI Paweł 1 KAWAŁEK Anna 1 LABER Konrad
Institution:
1 Czestochowa University of Technology, Faculty of Production Engineering and Materials Technology, Czestochowa, Poland, EU, dyja@wip.pcz.pl, pawelszyinski@wip.pcz.pl, kawalek@wip.pcz.pl, laber@wip.pcz.pl
Conference:
24th International Conference on Metallurgy and Materials, Hotel Voronez I, Brno, Czech Republic, EU, June 3rd - 5th 2015
Proceedings:
Proceedings 24th International Conference on Metallurgy and Materials
Pages:
227-232
ISBN:
978-80-87294-58-1
ISSN:
2694-9296
Published:
12th January 2015
Proceedings of the conference were published in Web of Science and Scopus.
Metrics:
529 views / 192 downloads
View Full-text Download PDF
Abstract

The paper presents results of numerical simulation of the asymmetric rolling process for band with shape ratio h0/D = 0.072 – steel grade S355J2G3. The study was conducted to determine the differences in the impact factor of different kinds of asymmetry on the band bending after leaving the deformation zone and the power parameters of rolling process. Introduction of single asymmetry, by varying the peripheral speed of the work rolls, does not have an effect on reduction of force parameters values. Based on the survey it was found that simultaneous introduction of second asymmetry, by varying the diameter of the work rolls, allows to lower rolling force and it also allows to obtain flat band after rolling process.

Keywords: Dual asymmetry, speed asymmetry, geometric asymmetry, plate rolling

© This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Scroll to Top